hardisk SMART

[henz]

screenshot with crystal disk info

my hd smart attribute show Current Pending Sector Count with an caution sign,,

any idea on how to fix ?

or something that should be done ?

i am on laptop

[HX1]

Well Everest shows that mine is the same way... and the number it states says 100, 100, 0 OK: Always Passes. Are you getting error messages or warnings fro your system or is it only in the software your using? Is this the only warning your showing?

[WaKa WaKa]

The disk its OK. I have the same value in 3 diferent disks

[mara-]

Well, on my two HDD, it shows 200, 200, and that's fine according to this program.

Cheers ;)

EDIT:

According to Wikipedia:

Potential indicators of imminent electromechanical failure

http://en.wikipedia.org/wiki/S.M.A.R.T.

[henz]

everest

ID Attribute Description Threshold Value Worst Data Status

C5 Current Pending Sector Count 0 100 100 1 OK: Always passes

hardisk sentinel

Current Pending Sector Count,0,100,100,OK (Always passing),000000000001,0,Enabled

i get a health status - caution with crystal disk info. (before this time i check it showed good).

overview tab from hardisk sentinel

There are 1 weak sectors found on the disk surface. They may be remapped any time in the later use of the disk.

At this point, warranty replacement of the disk is not yet possible, only if the health drops further.

It is recommended to examine the log of the disk regularly. All new problems found will be logged there.

No actions needed.

cause on laptop, i am not want to fall in trouble..

Thank you..

:cheers: