Betts1964 Posted October 31, 2019 Share Posted October 31, 2019 I built a cable/pulley system in my basement. I was wondering if you can can recommend a way to keep the loading pin from swinging when there are weights attached to them? I want the loading pin so it can go up and down freely but not/slightly swing side to side. Any help is greatly appreciated. https://imgur.com/GuvyLFS Link to comment Share on other sites More sharing options...
Arachnoid Posted October 31, 2019 Share Posted October 31, 2019 Its hard to judge from you image but you could put guides around the weights to keep them aligned i.e. a frame of upright angle irons on the corners. What weights are you using an image would help? Link to comment Share on other sites More sharing options...
Betts1964 Posted November 1, 2019 Author Share Posted November 1, 2019 all set. thx Link to comment Share on other sites More sharing options...
Reefa Posted November 1, 2019 Share Posted November 1, 2019 Topic marked as solved. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.