Jump to content

Cold Fusion and Beyond - Dr. Eugene Mallove


Ambrocious

Recommended Posts

When this interview was filmed in October 2000, Dr. Eugene Mallove was Editor-In-Chief of the magazine Infinite Energy and Director of the New Energy Research Laboratory in New Hampshire. He holds two MIT degrees in Aeronautical-Astronautical Engineering and a Harvard Doctorate in Environmental Health Sciences (Air Pollution Control Engineering). He has broad experience in high-technology engineering at companies including Hughes Research Labs, TASC (The Analytic Science Corporation) and MIT Lincoln Laboratory.

Dr. Mallove was the Chief Science Writer at MIT when the cold fusion story broke in March 1989, and he resigned in 1991 after his requested investigation into the altered cold fusion data at MIT (which helped to discredit the whole subject) was not properly done. The marginalization by the scientific establishment of the cold fusion topic bears strong resemblance to the similar marginalization of the ET/UFO topic: both have been ridiculed and defamed because they break established paradigms. As Dr. Mallove states in this interview, "There is nothing worse...than suggesting to academic physicists in particular, and academics in general, that they are not only wrong; they are disastrously wrong, catastrophically wrong." In his magazine, Dr. Mallove has advised us to remember the sentiments of Michael Faraday: "Nothing is too wonderful to be true."

Dr. Eugene Mallove - RIP: May 14, 2004

Edited by Ambrocious
Link to comment
Share on other sites


  • Replies 1
  • Views 949
  • Created
  • Last Reply

Top Posters In This Topic

  • Ambrocious

    1

  • STEEL

    1

Top Posters In This Topic

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...