Jump to content
  • More PCIe 5 NVMe SSDs thermal throttling and shutting down, requires cold reboot to revive


    Karlston

    • 448 views
    • 2 minutes
     Share


    • 448 views
    • 2 minutes

    Solid state drives (SSDs) are a pretty staple in most modern PC builds nowadays. Even SATA SSDs offer speeds much faster than hard disk drives (HDDs) do. And NVMe SSDs take that to another level as they are able to utilize the faster PCIe interface. However, it does come at a price. NAND flash memory inside SSDs is pretty heat-sensitive compared to mechanical HDDs. And with the latest generation (Gen5), NVMe SSDs are overheating, thermally throttling and even shutting down.

     

    1687865863_seagate-firecuda-540_story.jp

     

    We had already covered such cases before where Crucial's T700 and Corsair's MP700 were seen as severely underperforming and thermally throttling, respectively, due to the enormous amount of heat produced that the NAND chips couldn't cope with. The issue was happening with Phison's PS5026-E26 controller which is fairly common in PCIe Gen5 drives, and hence, back then, we speculated that other SSD models using the E26 would likely be affected as well.

     

    German tech site ComputerBase (CB) tested the Seagate FireCuda 540 and found that the drive was throttling heavily under load and was eventually shutting down. As you can see in the image below, the drive reached 87C which is prime throttle territory. The read speed of the drive drops heavily once such temperatures are reached. After encountering a shutdown, CB notes that the FireCuda 540 requires a cold (hard) reboot as a simple restart is not enough.

     

    1690323462_seagate_pcie_5_ssd_thermal_th

     

    Last time, Phison had stated that a heatsink is a must with PCIe 5.0 SSDs. In a statement, it explained:

     

    It is important to note that all E26 SSDs shipped without a heatsink are intended to be used with a heatsink. Most motherboards shipping with PCIe Gen5 enabled also include cooling specifically designed for Gen5 SSDs. We offer the 'bare drive' option to allow customers to use their existing cooling products.

     

    And this wasn't the first time either. Previously the company had suggested that for cooling Gen5 NVMe drives, even active cooling with fans may become necessary.

     

    Source


    User Feedback

    Recommended Comments

    There are no comments to display.



    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Add a comment...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...